Description:

Brand: Matek

Model: F722-WPX

MCU: 216MHz STM32F722RET6

IMU: MPU6000 (SPI)

Baro: DPS310 (I2C)

OSD: Pixel OSD/FrskyOSD (Uart6)

Blackbox: MicroSD socket (SPI)

6x UARTs(5 Spare) with built-in inversion

1x Softserial_Tx option

10x PWM outputs

1x I2C

4x ADC (VBAT, Current, RSSI, AirSpeed)

1x SH1.0_6pin connector (4V5/G/TX4/RX4/SDA/SCL) for GPS/compass

1x SH1.0_6pin connector for external USB and buzzer

Dual Camera Inputs switcher

Vbat filtered power ON/OFF switcher

PWM camera menu control: Not supported by INAV

DJI FPV air unit: any spare UART

Power

* 6~30V DC IN (2~6S LiPo)

* 132A high-precision Current Sense (Scale 250)

* PDB/Current sense resistor: 60A continuous, 132A burst.

* BEC 5V 2A for FC & Peripherals

* BEC Vx 5A for servos, 5V/ 6V option

* Vbat filtered output 1A for VTx and Camera

* LDO 3.3V 200mA

* Battery Voltage Sensor: 1:10 (Scale 1100)

FC Firmware

INAV target: MATEKF722WPX

Physical

Dimensions: 44 x 29 x 10 mm

Mounting: 25 x 25mm, u03a62mm

Weight: 20g w/ bottom plate and USB/buzzer adapter

* INAV2.5.x downloaded from configurator doesnu2019t support Barometer DPS310 and SD card. download customized firmware from here.

* inav_2.5.1_MATEKF722PX_DPS310_SD.hex

* DPS310 & SD in target will be supported officially by INAV2.6 and new configurator.

* If Baro canu2019t be detected. In INAV CLI mode, type command u201cset baro_hardware = DPS310u201d

* Since INAV2.6, pls use target MATEKF722WPX

* Update FrskyOSD to 2.0 https://github.com/FrSkyRC/PixelOSD/tree/master/firmware

* INAV configurator nightly version 2.6

Package Included:

1x FC F722-WPX

1x USB(Type-C)/Buzzer (Active) Adapter

1x Bottom plate, 44 x 29mm

2x JST-SH-6P to JST-SH-6P cables, 20cm

5x Brass standoffs, M2*4mm

10x screws, M2*3.5mm

Dupont 2.54 pins (Board is shipped unsoldered)